MCS 1-WAY Adjustable Non-Reservoir Dampers

Adjustment Instructions MCS 1-Way Dampers

How to install and adjust rebound on your MCS 1-Way adjustable non-reservoir dampers.

General information

  • The dampers are charged with nitrogen gas. Struts with 22 mm shafts are factory charged to 10 bar (150 psi). Aluminum dampers with 16 mm shafts are factory charged to 14 bar (200 psi).
  • Do not use impact tools to install pin mount top nuts.
  • The 8 mm brass hex nut at the top of the damper is the rebound adjuster. Do not use it to hold the shaft while installing the first top nut. Install the first top nut onto your mount and snug it with a wrench or socket, then cinch it with a quick jerking motion or a tap from a plastic hammer. This is more than enough to secure the shaft to the top mount. Install the second nut and tighten it against the first. Holding the first top nut with a tappet wrench (thin wrench) makes this easier.
  • When fitting the rebound adjuster knob onto the 8 mm brass hex nut, make sure it clears all body components.

Adjustment instructions

MCS 1-Way dampers are adjustable in rebound (extension). Bump (compression) forces adjust in proportion as you adjust rebound.

Rebound adjuster

The rebound adjuster sits at the top of the piston rod. On strut and pin mount dampers it is the 8 mm brass hex nut: attach the separately supplied rebound adjuster knob to it after installation. Aluminum dampers with a top eye have the rebound adjuster wheel inside the top eye.

Range: 19 positions (18 clicks). 0 = softest, 18 = stiffest. Arrows on top of the knob show the firmer and softer directions.

  • Clockwise (−) softens rebound (extension) damping.
  • Counter-clockwise (+) stiffens rebound (extension) damping.

When fitting the damper for the first time, set rebound to 8 clicks from 0. Turn the knob clockwise until it stops, backing off slightly if needed so it settles into a detent.

Once it stops turning, DO NOT force it any further. This is the “0” position. From here, turn the knob counter-clockwise 8 clicks. Rebound is now set.

Need help?

Call us toll free on 866.391.1091 or on 770.220.7940, or email info@motioncontrolsuspension.com.

Download the instructions

Get the full instructions as a PDF to keep with your dampers or print for the workshop.

See other instructions

Compare
2WNR

A unique double-adjustable damper with a feel all its own.

See Instructions
Compare
2WR

Remote reservoir performance with large blow off valves for stronger high speed control and improved compliance.

See Instructions
Compare
3WR

Builds off the 2WR with added low speed compression bleed to fine tune how driver inputs load the tires.

See Instructions
Compare
4WR

Maximum definition through fully independent high and low speed circuits and our most advanced blow off architecture.

See Instructions